Strymon Compadre Dual Voice Compressor & Boost
Your Dream Tone Starts Here.
Start your signal chain with the best possible version of your guitar tone. Treat your guitar signal to true studio quality analog compression with two distinct voices for smooth transparency or vintage squeeze. Hit the Boost switch to add clean boost or soft-clipped dirty boost, with the EQ curve of your choice. Mix in some dry signal for natural attack even with extreme compression settings. Feel the perfectly tailored dynamic response, feeding your amp and effects just what they need to sound their best.
Sound Design
Vintage Inspiration, Modern Execution.
The Compadre design project started with a study of some of the finest analog compressors ever created, inspiring and guiding our circuit design process. Utilizing a VCA in the compression circuits allowed us to carefully tune the exact response and dynamics we desired for each voicing.
For Studio mode, our goal was to achieve the musical and transparent sound found within our favorite studio rack units and the best vintage studio console bus compression. Careful tuning of our detection circuit granted us exacting control over decay, especially important for Squeeze mode. With ample sustain on tap, we paid special attention to creating a completely smooth decay, with no unwanted pumping artifacts.
Ins, Outs, and Switches
- High impedance ultra low-noise discrete Class A JFET preamp input
- Low impedance mono output
- Output VCA allows Compadre to function as a volume pedal when a standard TRS expression pedal plugged into the dedicated Volume jack
- Compatible with MiniSwitch for remote selection of a Favorite preset
- Compatible with MultiSwitch Plus for remote selection of 3 presets
- Full featured MIDI control. Access to 300 presets and remote parameter control via quarter-inch TRS. (requires Strymon MIDI EXP Cable or MIDI > TRS interface)
Audio Quality and More
- Selectable True Bypass (electromechanical relay switching) or ultra low-noise Buffered Bypass
- Strong and lightweight anodized dark red aluminum chassis
- 9V DC power supply included. Power requirements: maximum 9 volts DC center-negative, with a minimum of 150mA of current
- Compressor Signal/Noise: 109 dB typical
- Dimensions: 4.5” deep x 4” wide x 1.75” tall (11.4 cm deep x 10.2 cm wide x 4.4 cm tall)
- Designed and built in the USA